Figure 21 - Assigning Ip Configuration; Figure 22 - Edit Ethernet Node Confirmation - Datalogic AMT58*-PN Series Instruction Manual

AMT58x-PN ProfiNET®
In the Set IP configuration group, enter the required IP address in the
IP address field; enter the required subnet mask in the Subnet mask
field below. Press the Assign IP configuration button to confirm.

Figure 21 - Assigning IP configuration

The following confirmation message will appear on the screen.

Figure 22 - Edit Ethernet Node confirmation

Now press the OK button to close the message and then press again
the Browse... button in the Edit Ethernet node page to find all the
nodes connected to the network and check whether the encoder is
listed properly in the page.
29