Resetting The Parameters To Default Factory Values; Figure 27 - Parameter Access Point Help Messages - Datalogic AMT58*-PN Series Instruction Manual

Profinet absolute encoders

Table of Contents

AMT58x-PN ProfiNET®

Please note that a description / help message appears on the display

when you move the cursor over the items listed on the left.

5.5 Resetting the parameters to default factory values

Default values are provided to each parameter of the device and are

preset at the factory by Datalogic Automation s.r.l. engineers. The

first time you install the encoder, it will operate using the default

values. They allow the operator to run the IO device for standard and

safe operation. They are plainly not optimized for specific application

yet they provide maximum performance for most systems. To suit the

specific application requirements it may be advisable and even

necessary to enter new parameters instead of the factory default

settings.

There could be exceptional circumstances where it would be

necessary for you to restore the default values of the settable

parameters. When this is the case, you have to use the Reset

command.

NOTE

When you restore the default values, please always consider that:

 the encoder parameters will be restored to the default values;

 the encoder offset will be reset;

 the Device Name will be lost and replaced with a blank string;

 the IP address wil be set to 0.0.0.0;

 the parameters associated with the IP range will be set to 0.

WARNING

The execution of this command causes all the values which have

been set previously next to each parameter to be overwritten!

Table of Contents