Figure 20 - Browsing The Network - Datalogic AMT58*-PN Series Instruction Manual

AMT58x-PN ProfiNET®
If you want to change both the IP address and the subnet mask you
can also proceed as follows.
Press PLC, Ethernet and then Edit Ethernet node command in the
menu bar of the HW Config window. Press the Browse... button to
find all the nodes connected to the network. Select the IO device you
want to assign the IP address to. The MAC address of the encoder is
written on the encoder label. Select the LIKA ROTACOD device type
and then press the OK button to confirm.

Figure 20 - Browsing the network

28