Table of Contents
Advertisement
AMT58x-PN ProfiNET®
NOTE
The complete list of machine data and relevant default parameters
preset by Datalogic Automation s.r.l. engineers is available on page
130.
When you need to restore the default values proceed as follows.
Press PLC, Ethernet and then Edit Ethernet node command in the
menu bar of the HW Config window. In the Edit Ethernet Node dialog
box press the Browse... button to find all the nodes connected to the
network. Select the LIKA ROTACOD device type you need to reset
the parameters. The MAC address of the encoder is written on the
encoder label. Press the OK button to confirm.
Figure 28 - Restoring default values
33
Advertisement
Table of Contents
