Anybus CompactCom 40 Network Manual page 200

Host Application Objects
Command Details: End_Pause
Details
Command Code
Valid for:
Description
This command is sent to the host application when the system wants to return the system from a pause mode
back to "Ready to operate" mode. In the response message the number of milliseconds to actualize the switch
is returned.
• Command Details
(none)
• Response Details
Field Contents
Data[0] Time To Operate (low word, low byte)
Data[1] Time To Operate (low word, high byte)
Data[2] Time To Operate (high word, low byte)
Data[3] Time To Operate (high word, high byte)
If the application is unable to end the pause it shall return the error code in the table below.
#
Error code
0x0D
Invalid state
Anybus CompactCom 40 EtherNet/IP IIoT Network Guide
11h
Object
Description
Given the state of the device, it is currently not possible to end the pause
Comments
Time needed to switch to "Ready to operate"
198 (244)
SCM-1202–069 1.9 en-US