Anybus CompactCom 40 Network Manual page 13

Basic Operation
IP settings
Physical Link Settings
The parameters in the Network Configuration Object (04h) are available from the network
through the built in web server, and through the TCP/IP Interface Object (CIP).
The parameters in the Network Configuration Object (04h) are available from the network
through the TCP/IP Interface Object (CIP).
See also...
• Web Server, p. 24
• TCP/IP Interface Object (F5h), p. 122
• Ethernet Link Object (F6h), p. 125
• Network Configuration Object (04h), p. 134
• Secure HICP (Secure Host IP Configuration Protocol), p. 215
Anybus CompactCom 40 EtherNet/IP IIoT Network Guide
These settings must be set properly in order for the module to be able to participate on
the network.
The module supports DHCP, which may be used to retrieve the IP settings from a DHCP-
server automatically. DHCP is enabled by default, but can be disabled if necessary.
By default, the module uses auto negotiation to establish the physical link settings,
however it is possible to force a specific setting if necessary.
(CIP object)
(CIP object)
(Anybus Module Object)
11 (244)
SCM-1202–069 1.9 en-US