Pager Setup - Bosch Security Escort SE2000 Series Training Manual

216 en | System menus and dialogs
Max Report Spooler Bytes
Max Receiver Buffer
Max Transmit Buffer
Hardware Overrun
Buffer Overflow Count
Overload Level
Overload Count
[Reset Status]
[Refresh Data]
[Cancel]
8.3.10

Pager setup

This dialog sets up remote pager access for troubles (service) and alarms (security).
2017.08 | V2.18.1.0 | DOC
This value is the maximum number of bytes spooled for the
printer for Guard Tour Reports at one time. If displayed in
yellow, more than 50% of the queue was in use.
This value is the maximum number of bytes received from
transponders on this serial port, but not yet processed by
the system. If displayed in yellow, more than 50% of the
queue was in use.
This value is the maximum number of bytes processed by
the system, but not yet transmitted to the transponders on
this serial port. If displayed in yellow, more than 50% of the
queue was in use.
This is the number of times a byte was lost by the hardware
for a serial port because it was not fast enough to process
the byte into the input buffer.
This is the number of times a byte was lost by the software
for a serial port because the input buffer overflowed. Bytes
were placed into the input buffer faster than the system
could process them.
This is a measure of the amount of time peak traffic on this
serial port was greater than the system's ability to handle it.
The system automatically sheds non-essential tasks when
this value rises.
This is a measure of the number of times peak traffic on this
serial port was greater than the system's ability to handle it.
The system automatically sheds non-essential tasks when
this value rises.
Clicking this button resets all values in this shown in this
dialog.
Clicking this button refreshes all values shown in this dialog.
The values are not automatically updated when the dialog is
left open.
Clicking this button closes the dialog window.
Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd