Bosch Security Escort SE2000 Series Training Manual page 79

Security Escort
Ignore
Communications
Failure
[Insert New]
[Edit Data]
[Kill Transponder]
[Delete Point]
[Copy]
[Print]
[Beginning]
[Previous]
[Next]
[End of File]
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
This checkbox allows communications failures to be ignored for this
transponder. It is used during a new installation for transponders that
are not yet fully on line. During system maintenance, when a
transponder is out of service for a while, it is used so that the
communications failure messages will not flash on the screen and
distract the operator. Checking this checkbox causes the system to
ignore communication failure. Therefore, if communications fail with
this transponder, the area this transponder protects will not be
protected, and alarms from subscribers in that area will be missed
without the operator's knowledge. This checkbox should not be
checked in a live system.
Clicking this button displays a new Edit Transponder's Database
Record dialog window. This is used to enter a new transponder to the
database.
Clicking this button allows the currently displayed transponder's
database record to be modified.
Clicking this button deletes the currently displayed transponder's
database record. If the transponder is "killed", its data is permanently
deleted and cannot be recovered.
Clicking this button deletes the currently displayed point from the
current transponder's database record. If the point is deleted, its data
is permanently deleted and cannot be recovered.
Clicking this button copies the currently displayed transponder's
database record into a new transponder record. This allows similarly
configured transponders to be programmed once then copied into a
new record.
Note: It is not possible to edit the Transponder ID itself. If this
should be necessary, the [Copy] button can be used to produce
another Transponder Database entry duplicating the first, but with
the Transponder ID blank. The new Transponder ID can be entered,
the new data saved by using the [Save] button, and the old
transponder entry can be deleted using the [Kill Transponder]
button.
Clicking this button prints the currently displayed transponder's
database record.
Clicking this button changes the currently displayed transponder to the
first transponder in the database.
Clicking this button changes the currently displayed transponder to the
previous transponder in the database.
Clicking this button changes the currently displayed transponder to the
next transponder in the database.
Clicking this button changes the currently displayed transponder to the
last transponder in the database.
Training Manual
79
2017.08 | V2.18.1.0 | DOC