Bosch Security Escort SE2000 Series Training Manual page 69

Security Escort
Figure 6.2: Remote Comm Port Setup Dialog
Network Port
Modem Port
System Serial 1/2
COM
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
This port connects the master and slave computers of the
Security Escort System. If this system has only a single
computer, this setting should be set to none.
This port typically connects to the modem for remote access
and pager dial out. If set in the Remote Setup dialog, use
this port without a modem for direct connection to a
computer that is always on line.
This is a general-purpose serial port. Its function is set up in
the Remote Setup dialog.
The actual physical communication port over which these
communications are carried.
Training Manual
69
2017.08 | V2.18.1.0 | DOC