Bosch Security Escort SE2000 Series Training Manual page 154

154 en | Troubleshooting transponders, points, receivers, and alert units
Notice!
Important!
The record entries in the ".dat" file are merged with existing records in the Subscriber
Database. If the Subscriber ID field in the file matches a record in the Subscriber Database,
the existing record will be merged with the corresponding record entry in the file. Unmatched
records will be inserted into the Subscriber Database as new records.
The total number of records is subject to the number of subscribers allowed for the
purchased license. You can find this limit in the menu About > About... If this limit is reached
during the merge, a pop-up message appears to inform the user.
The [Data Merge] button is only visible to users or operators who are assigned the minimum
security level of "Install". After preparing the merge file, start the Security Escort software. Go
to menu File > Subscriber Database dialog, and click the [Data Merge] button. A pop-up
dialog appears asking for the location of the merge file. Navigate to the merge file and click
the [Open] button.
Figure 7.27: Merge Confirmation Dialog
Be patient, as it may take a while, and watch for the disk activity to stop. If the data is merged
successfully, a pop-up confirmation message appears. If the data is not merged successfully, a
pop-up error message appears. The error message will indicate the likely issue which causes
the merge to fail.
2017.08 | V2.18.1.0 | DOC Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd