Bosch Security Escort SE2000 Series Training Manual page 165

Hide thumbs Also See for Security Escort SE2000 Series:
Table of Contents

Advertisement

Security Escort
        </Area>
    </Areas>
</Transponder>
<Transponder TransponderID="1" Name="South Point Hospital"
IsIPConnected="0" IPAddress="" PortNumber="0" CommPortIndex="0">
    <Receivers>
        <Receiver Address="6" PointType="0" AlgoNumber="0" AlarmIcon="9"
Rx_LocationText="1st Floor by South Exit Door" MapXPosition="430"
MapYPosition="479" SensitivityAdjust="0" BitmapNumber="0" />
        <Receiver Address="7" PointType="0" AlgoNumber="0" AlarmIcon="9"
Rx_LocationText="1st Floor Center of Main Lobby" MapXPosition="429"
MapYPosition="215" SensitivityAdjust="0" BitmapNumber="0" />
    </Receivers>
</Transponder>
The following attributes are applicable to the respective elements.
<Transponder> element
Attribute
TransponderID
Name
IsIPConnected
IPAddress
PortNumber
CommPortIndex
<Receiver> element
Attribute
Address
PointType
Robert Bosch (SEA) Pte Ltd
Troubleshooting transponders, points, receivers, and alert units | en 165
Value
ID of the transponder. 1-255. This field should contain only
numeric ASCII characters.
Name of the transponder. This field may be up to 24 characters.
This field may contain any printable ASCII character except the '?'
0 if transponder is connected via RS232, 1 if transponder is
connected via TCP IP. This field should contain only numeric
ASCII characters.
The value is blank if IsIPConnected is 0 (RS232). The value should
contain a valid IP address if IsIPConnected is 1 (TCP IP).
The value is 0 if IsIPConnected is 0 (RS232). The value is 1-65535
if IsIPConnected is 1 (TCP IP).
The value is always 0 if IsIPConnected is 1 (TCP IP). If
IsIPConnected is 0 (RS232), the following values are valid: 0 (A),
1 (B), 2 (C), 3 (D), 4 (E), 5 (F), 6 (G), 7 (H), 8 (I), 9 (J), 10 (K), 11
(L)
Value
Address of the receiver. 0-63. This field should contain only
numeric ASCII characters.
Type of point. This field should contain only numeric ASCII
characters. Valid values are: 0 (receiver), 1 (Alert unit), 2 (Virtual)
and 7 (None).
Training Manual
2017.08 | V2.18.1.0 | DOC

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents