Installation And Operation Notes - Bosch Security Escort SE2000 Series Training Manual

46 en | System wiring
Dimensions:
Power:
Recommended
Cable:
4.6.3

Installation and operation notes

–
–
–
The pinouts of male DB9 serial port of Moxa NPort 5150 are as follows:
Figure 4.8: Moxa NPort 5150 Male DB9
Pin Number
Notice!
Third party user interfaces are subject to change without notice at the sole discretion of the
respective providers but configuration setting shall remains as specified.
Follow the instructions below to set up the NPort 5150 device and use the serial cable to
connect the transponder to the Ethernet network.
1.
2017.08 | V2.18.1.0 | DOC
52 mm (2.05 in) x 80 mm (3.15 in) x 22 mm (0.89 in)
Use the included 12 – 48 V DC on barrel connector
Standard male DB9 to female DB9 serial cable (not included).
The Moxa device must be powered at all times. Use the included power adapter.
A standard male DB9 to female DB9 serial cable is used to connect the transponder to
the Moxa device.
Instructions on setting up the Moxa device is based on the recommended model NPort
5150 (firmware version: 3.4 Build 11080114).
RS-232
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 --
Connect NPort 5150 to the Ethernet network.
RS-422/RS-485
(4W)
TXD-(A)
TXD+(B)
RXD+(B)
RXD-(A)
GND
--
--
--
--
Training Manual
Security Escort
RS-485
(2W)
--
--
Data+(B)
Data-(A)
GND
--
--
--
--
Robert Bosch (SEA) Pte Ltd