Bosch Security Escort SE2000 Series Training Manual page 54

54 en | System wiring
Configuration procedure
Notice!
For more details refer to the ProxLink Radio Module User's Manual
Required equipment
–
–
–
–
Configure
Select one of seven radio channels (902 MHz to 928 MHz). Make certain that the channel
chosen is the same for all the ProxLink located at the transponders and for the ProxLink at the
Central Console computer.
Select one ProxLink for your Central Console computer. The serial number (located on a silver
tag on the bottom of the ProxLink) of this ProxLink must be entered in the Destination Serial
Number and Serial # Filter location on all ProxLink Radios connected to the transponders.
1.
2.
2017.08 | V2.18.1.0 | DOC
ProxLink Radio Module
PC with RS-232 port running a terminal emulation software package. Select Start >
Programs > Accessories > Hyper Terminal.
ProxLink DB-9 to DB-25 Female RS-232 Cable
9 V DC Power Supply
Attach the PC to the ProxLink using the ProxLink RS-232 cable. Attach the DB-9
Connector to the ProxLink and attach the DB-25 female connector the PC. Gender
changers or DB-25 to DB-9 converters may be required depending on your serial port
connector type.
Start your terminal emulation software (Hyper Terminal). Configure the ProxLink as
follows: 9600 Baud, 8 Data Bits, 1 Stop Bit, and no parity.
Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd