Transponder Database Dialog - Bosch Security Escort SE2000 Series Training Manual

Security Escort
6.4.2

Transponder Database dialog

The Transponder Database is established at system set-up and contains all necessary
configuration data for each transponder, receiver and alert unit. It describes the basic
structure of the installation, including all device names, locations, types, multiplex addresses,
etc. This information is used by the Central Console to generate alarm and test displays on the
Central Console and in determining which alert units are to be activated.
Figure 6.4: Find Transponder's Database Dialog
Access the Transponder Database from the File menu on the main menu bar. The following
table describes the elements of the Find Transponder's Database Record dialog.
Type
Name
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
This field indicates the type of transponder record that you are
currently viewing. Currently, there is only one type of transponder
available.
This drop-down list contains the names of the transponders. Selecting
the name of the transponder in the drop-down list displays information
of the transponder record in the dialog window. The transponder
names are assigned during set-up and are used to indicate the physical
location of the transponder, or the region of the protected area
covered by a particular transponder.
Training Manual
77
2017.08 | V2.18.1.0 | DOC