Subscriber (individual) Pager Setup
In the subscriber database
select the record for the
desired individual. Press Edit
data then press Advanced,
the dialog below will be
displayed.
The pager ID is required for
all individual pagers dial-up
and local. If the phone
number and password are
assigned the page will be sent
over the modem connection.
If the phone number and
password fields are blank the
page will be routed to the
local paging system. If you do
not desire this individual to
have pager support leave the
phone number, password and
pager ID fields all blank.
Figure 30: Subscriber Database Advanced dialog
If the pager information is entered above this individual may be assigned to 3 paging groups. Each group will
accept 8 members maximum. Remember it takes time to communicate with a paging service, therefore only add
members to a group if they need to be there, otherwise you may slow the paging report to people that must
respond.
A pager group may contain members accessed by the local paging system and members that require
dial-up access. Dial-up access typically takes much longer and it may slow pages to the local paging
system.
Security Escort Training
Page 88 of 142