Set The Address - Bosch Security Escort SE2000 Series Training Manual

36 en | System wiring
Wiring from SE485 to transponders can be home-run (individual), daisy-chain (from device to
device), or a combination of both. T-tapping is okay. The recommended cable is 4-conductor,
22 AWG (0.8 mm).
4.3.5

Set the address

Every transponder in the system must have its own address. Set the address on the
transponder using the dip switches in the upper-right corner. See figure below.
Figure 4.2: Transponder
2017.08 | V2.18.1.0 | DOC Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd