Bosch Security Escort SE2000 Series Training Manual page 49

Security Escort
–
–
The pinouts of female DB25 serial port of Lantronix are as follows:
Figure 4.9: Lantronix UDS1100 Female DB25
Pin Number
Robert Bosch (SEA) Pte Ltd
Do not use the female DB9-to-male DB25 serial cable included. A modified serial cable
must be used to connect the transponder to the Lantronix device.
Instructions on setting up the Lantronix device is based on the recommended model
UDS1100.
RS-232 Signals
1 Chassis Ground
2 Transmit Data
3 Receive Data
4 Request to Send
5 Clear to Send
6 Data Set Ready
7 Signal Ground
8 Carrier Detect
9 ---
10 ---
11 Receive Clock Out
12 ---
13 ---
14 ---
15 Transmit Clock In
16 ---
17 Receive Clock In
18 Local Loopback
19 ---
20 Data Terminal Ready
21 Remote Loopback
22 ---
Training Manual
System wiring | en 49
2017.08 | V2.18.1.0 | DOC