Popup Trouble Filter - Bosch Security Escort SE2000 Series Training Manual

Security Escort
RF point troubles
Transponder maps
Receive level maps
Database errors
Transponder troubles
Point troubles
Login changes
Network communications
Modem communications
Analyze alarms
Master computer switch
Transponder data view
Printer output
8.3.3

Popup trouble filter

The Security Escort System contains many built-in self testing features. Each transponder
tests the condition of the receivers and alert units connected to it.
When the transponder finds a device reporting a trouble condition, it communicates the
problem and the device identity to the Central Console. This generates a brief alert tone,
displays a pop-up message for the operator, and sends an optional pager message. The
message indicates the nature of the trouble and instructs the operator on the proper course of
action. The event is recorded on the hard disks of both the main and backup computers and
on the printout.
The status of the device is recorded in the Transponder Current Status menu item under the
Setup menu.
Robert Bosch (SEA) Pte Ltd
Output all reported radio frequency communication of receiver
and alert unit troubles. Typically this item would be checked for
devices used to monitor problems.
Outputs all transponder status maps. This selection is only used
for diagnostics. Leave this item unchecked.
Outputs all maintenance alarm receive level maps. This selection
is only used for diagnostics. Leave this item unchecked.
Outputs all reported database errors. This item is checked.
Outputs all reported transponder troubles. This item is checked
for devices used to monitor problems.
Outputs all reported receiver and alert unit troubles. This item is
checked for devices used to monitor problems.
Reports all new system operator login and logout activity.
Records all communications between networked computers.
This selection is only used for engineering diagnostics. Leaving
this item selected, generates a significant amount of history and
fills up the hard disk drive very quickly and may bog down the
system during high traffic times. Always leave this item
unchecked.
Records all communications to the modem for remote
communications and pager access. This selection is only used for
diagnosing pager communication problems. Leave this item
unchecked.
This option outputs data allowing an engineer to evaluate how
well the location algorithm is performing. Leave this item
unchecked.
Records when the master and slave computers switch roles.
Allows the data created by the Transponder Data View screen to
be output. This selection is only used for engineering
diagnostics. Leave this item unchecked.
Allows the data being sent to the printer to be sent to other
outputs. This item is unchecked.
Training Manual
System menus and dialogs | en 199
2017.08 | V2.18.1.0 | DOC