Modifying Existing Transponder Entry - Bosch Security Escort SE2000 Series Training Manual

Security Escort
Figure 6.5: Blank Dialog Resulting from Selection of [Insert New] Button
The new elements of the Edit Transponder's Database Record dialog.
Trouble Type Text
Trouble Tamper Text This is the text that will be shown in the trouble dialog when the
Trouble Response
Text
Show Points
Show Areas
6.4.4

Modifying existing transponder entry

If the transponder is already defined in the Transponder Database, the [Edit Data] button is
used to complete or modify the data. The data that can be modified is the same when creating
a new transponder entry (see Creating a new transponder entry, page 80).
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
This is the text that will be shown in the trouble dialog when the
remote key input on the transponder goes active (shorted).
remote key input on the transponder goes into trouble (open).
This is the text that will be shown in the trouble dialog as the response
test. The actions the responding individual should take.
If selected, the lower section of the Transponder Database dialog will
show the point's (receiver, virtual receiver or alert unit's) database
values.
If selected, the lower section of the Transponder Database dialog will
show the alarm area's database values.
Training Manual
81
2017.08 | V2.18.1.0 | DOC