Wiring; Set The Address; Moxa Interface; Introduction - Bosch Security Escort SE2000 Series Training Manual

Security Escort
4.5.4

Wiring

Wire the alert unit using the figure below:
4.5.5

Set the address

Every module on each multiplex bus of the transponder must have its own address. Set the
address on the alert unit using the address switch.
Use only address numbers 0 through 7. Do NOT use address numbers 8 and 9.
4.6

Moxa interface

4.6.1

Introduction

The Moxa interface is used between the RS-232 signal bus of the Security Escort transponder,
and the Ethernet connection of the Local Area Network (LAN) in order to communicate with
the Security Escort Central Console.
4.6.2

Specifications

Recommended
Model:
Robert Bosch (SEA) Pte Ltd
NPort 5150
Training Manual
System wiring | en 45
2017.08 | V2.18.1.0 | DOC