Bosch Security Escort SE2000 Series Training Manual page 87

Security Escort
[Locate]
[Cut]
[Copy]
[Paste]
[Save]
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
When clicked, the Edit Transponder's Database Record dialog
disappears and the cursor changes to a cross hair. Moving the cursor to a
point on the map and clicking the left mouse button scrolls the map so
the point is at the center of the screen and all previously defined
receivers and areas are shown with numerical labels.
When the map is showing the location of the desired receiver, move the
cross hair to the exact location of the receiver and click the right mouse
button. The Edit Transponder's Database Record dialog reappears and
the selected location is entered into the X and Y coordinates.
When the map shows the desired location, move the cross hair to the
exact location of the first point of the polygon that describes the
boundary of the area and right click. Move the cursor to the second point
of the polygon and again right click. The computer draws a straight line
between the first and second points. Repeat this process drawing all
sides of the polygon to define the area. To close the polygon, place the
last point on top of the first point. The polygon can have up to nineteen
sides and no two lines of the polygon may cross each other. If you try to
create more than nineteen sides, the computer automatically closes the
polygon with the nineteenth side. When the polygon is closed, it can be
crosshatched to make it more visible. After the polygon is complete,
double click the left mouse button to return to the Edit Transponder's
Database Record dialog.
If the area being defined is a virtual monitor "fence" area for wandering
alarms, the monitor fence (area boundary) should be drawn at least 7.62
m (25 ft) past the area to be protected to reduce potential false alarms.
This is due to the basic location accuracy of the Security Escort system.
If the cross hair cursor is displayed and you want to exit without changing
any coordinate values, press the <Esc> key and the Edit Transponder's
Database Record dialog reappears.
Clicking this button copies the displayed point or area data to a clipboard
and returns all values to their defaults.
Clicking this button copies the displayed point or area data to a
clipboard. Displayed values are not changed.
Clicking this button copies the clipboard values to the displayed point or
area data. The values on the clipboard are not changed and can be copied
to more points or areas.
Clicking this button saves all changes to the database.
Training Manual
87
2017.08 | V2.18.1.0 | DOC