Remote Setup Dialog - Bosch Security Escort SE2000 Series Training Manual

70 en | Central Console, computer setup and programming
Baud
CR/LF
CR Only
LF Only
6.3

Remote setup dialog

This dialog sets up the remote access and system serial port parameters.
Figure 6.3: Slave and Remote Computer Access Parameters Dialog
2017.08 | V2.18.1.0 | DOC
The speed at which characters are transmitted on this serial
port. This setting must match the baud rate of the device
connected at the other end of this serial connection. This
setting should always be at the highest speed that both
connected devices have in common. Modem connections are
typically much more efficient, if the baud rate is set
significantly faster than the modems rated speed (for a 28.8
modem, set the baud rate to 57600 or 115200). The default
setting is 9600 baud.
Appends carriage return and line feed characters at the end
of each string transmitted (default). Only functions with the
system serial ports (ignored on the network and modem
ports).
Appends a carriage return character at the end of each
string transmitted. Only functions with the system serial
ports (ignored on the network and modem ports).
Appends a line feed character at the end of each string
transmitted. Only functions with the system serial ports
(ignored on the network and modem ports).
Training Manual
Security Escort
Robert Bosch (SEA) Pte Ltd