Digital Impulse Interface - WAGO -I/O-SYSTEM 750 Technical Description, Installation And Configuration

5.3.5.5

Digital Impulse Interface

PNIO
Module type
1DII
PNIO
Module type
1DII
Parameter
Asynchronous diagnostic
message
channel x
WAGO-I/O-SYSTEM 750
PROFINET IO
Configuration and Parameter Setting of the Modules
Module type member
75x-635
Length Bit allocation
[Bit]
7 6 5
2 2 2
PD
4
F
RA
Input data
channel 0 Byte 0
Input data
channel 0 Byte 1
channel 0 Byte 2
\ - - - - - - - - - - - - - - Input - - - - - - - - - - - - - - /
PD Control 0 / Register REQ
4
RW
RA
Output data
channel 0 Byte 0
Output data
channel 0 Byte 1
Output data
channel 0 Byte 2
\ - - - - - - - - - - - - - - Output - - - - - - - - - - - - - - /
Value
locked*)
released
*) Default settings
Inputs
4 3 2 1 0
2 2 2 2 2
Status 0 / Register RES
Channel 0 / Table 0
Register date RD
Table 0, LB
Register date RD
Table 0, HB
Input data
Channel 0 / Table 0
Register date WR
Table 0, LB
Register date WR
Table 0, HB
Significance
The following occurs per diagnostics data sets and
diagnostics alarm with external faults
•
not transferred to the I/O Controller
•
transferred to the I/O Controller
I/O Modules
Instances
PNIO-Data type
Input
Unsigned 8
1
Unsigned 8[3]
Note
2 byte and 1 word (4 byte) are applied in the
output process image of the station proxy
(fieldbus coupler) are assigned to the
physical module by fitting the slot with this
module. The quality rating of the bytes
within the word is a result of the selected
data format. This module enables access to
the register structure of the I/O module for
configuration purposes. Two byte process
data qualifiers (IOPS, IOCS) are managed in
the direction of the I/O controller in the
cyclic PROFINET IO telegram for this
module.
• 209
Output
1