WAGO -I/O-SYSTEM 750 Technical Description, Installation And Configuration page 99

Missing parameters for both the station substitute (buscoupler) and the
modules (I/O modules) are also reported using an extended channel
diagnostics. Fault type 0x001F is classified as missing parameters in
accordance with the standard.
Fault type "missing parameters (0x001F)"
Extended
fault type
Faults occurring on the internal data bus system are also indicated by
transmitting an extended channel diagnostics. This is a manufacturer specific
fault that is displayed using the fault type 100
available in the following table.
Fault type "Internal bus fault (0x0100)"
Extended
fault type
WAGO-I/O-SYSTEM 750
PROFINET IO
Additional
value
0x0009 0xC0018009
Additional
value
0x0001 0x00000106
0x0003 0x01100300
0x0003 0x01110300
0x0003 0x01120300
0x0003 0x01140300
0x0003 0x01180300
0x0004 0x011204xx
0x0005 0x011005xx
Description
Module or coupler are not configured.
H
Description
The module configuration that has been determined on the
internal bus after AUTORESET differs from the
configuration performed before the internal bus fault
occurred.
Internal bus protocol fault due to internal bus RESET fault.
Internal bus protocol fault due to command fault.
Internal bus protocol fault due to faulty input data.
Internal bus protocol fault due to faulty output data.
Internal bus protocol fault caused by timeout.
Internal bus interruption after module slot xx (xx = 0 ... 250).
Internal bus initializing fault because of an abortive register
communication with the module on slot xx (xx = 1 ... 250).
PROFINET IO 750-340
Diagnostics
. Additional fault information is
• 91