WAGO -I/O-SYSTEM 750 Technical Description, Installation And Configuration page 93

Article
number
750-553,
750-555,
750-557,
750-559,
750-560
750-610,
750-611
750-630
750-635
750-637
750-641
750-642,
750-650,
750-651,
750-653
WAGO-I/O-SYSTEM 750
PROFINET IO
Data
Fault type
format
WORD
0x09 / 9
BIT
0x11 / 17
0x12 / 18
DWORD
0x16 / 22
0x1A / 26
OTHER
0x09 / 9
OTHER
0x09 / 9
OTHER
0x09 / 9
0x1A / 26
OTHER
0x07 / 7
Significance
Fault Output short circuit
Internal fault (e.g. hardware fault)
Transmitter or load Field voltage too low or not present
voltage missing Fuse defective or not present
Fuse defective
Sampling fault An incorrect data frame exists, i.e. the data
frame is not terminated with zero (possible
wire break of clock lines). SSI has no power
supply or data line break, or D+ and D- have
External fault been inverted.
Fault Wave speed has not been set
or
inadequate stop impulse
or
the maximum wave speed has been exceeded
or
timeout, no measurement values exist,
measurement value is invalid
or
fault when setting the wave speed or zero
point has occurred
or
invalid transmitter selection, the selected
transmitter address is invalid because of
the missing initialization
Fault
Fault General module faults such as POST of the
External fault internal flash memory, DALI bus faults
(continuous short circuit or open circuit),
however, no faulty electronic ballasts.
Upper limit value The receiver buffer is completely full, there
exceeded is a danger of loss of data
PROFINET IO 750-340
Diagnostics
• 85