Data Set For Identification And Servicing Purposes (I&M 0) - WAGO -I/O-SYSTEM 750 Technical Description, Installation And Configuration

Byte
offset
14 / 15
16 / 17
10 / 11
12 / 13
The sub-module data sets follow direct one after another. Their number is
stored in the head structure. The next module data set follows after the sub-
module data sets.
3.1.7.2.4 Data Set for Identification and Servicing Purposes (I&M 0)
This data set allows to read the device information that may be required for
the system documentation and for service purposes.
Byte
offset
WAGO-I/O-SYSTEM 750
PROFINET IO
Data type
WORD 0x00 0x01
0x00 0x00
DWORD
0x00 0x00
WORD
Information Description
0 0x00 0x20 Block type
2 0x00 0x38 Block length = 56 Byte
4 0x01 0x00 Block version 1.0
6 0x01 0x1D
Manufacturer ID WAGO 285
8
0x37 0x35
10 0x30 0x2D
12 0x33 0x34
14 0x30 0x20
16 0x20 0x20
... ... ...
26 0x20 0x20
28 0x30 0x30 MAC-ID WAGO filled out with spaces
"0030DEKLMNOP
30 0x33 0x30
32 0x44 0x45
Description
Sub-module slot with target and actual deviation
Identification of the physically connected sub-module
= 0
Sub-module status
0x0000 no sub-module is connected
0x0001 Physically connected and configured
sub-module do not correspond
0x0002 Sub-module is locked by the I/O
controller
0x0003 reserved
0x0004 one application is accessing the sub-
module
0x0005 reserved
0x0006 reserved
0x0007 Physically connected and configured
sub-module do not correspond but are
compatible
0x0008
... reserved
0xFFFF
WAGO order number
filled out with spaces
„750-340
"
PROFINET IO 750-340
Diagnostics
D
"
• 93