Table of Contents
Advertisement
2074
User Manual
Selecting a Run
Mode
1
3-18
The Model 2074 offers four run modes: Continuous, Triggered,
Gated and Burst.
The selected waveform is repeated continuously when the
instrument is set to operate in Continuous mode. The continuous
output can be turned on and off from a remote interface, and thus
controlling the start and stop of the waveform from an external
source. The operating mode defaults to continuous after reset.
Triggered, Gated, and Burst modes require an external signal to
initiate output cycles. In some case, an internal trigger generator is
available to generate the required trigger stimuli without the need to
connect to external devices. Figure 3-8 show the run mode options.
Press one of the soft keys in the left to select the required run
mode.
Description of the various runs modes and the parameters that are
associated with each run mode is given in the following paragraphs.
Figure 3-8, Run Mode Options
Burst run mode is shown in Figure 3-8 as an example
however, the following description applies to all Run
Mode menus.
In general, a specific run mode is selected from the Run Mode soft
key menu. The screen as shown in Figure 3-8 is displayed. Proceed
to select the run mode and to program parameters as follows:
1. Press one of the soft keys to select from: Continuous,
Triggered, Gated or burst. The output will immediately be
Note
2, 4
Advertisement
Table of Contents
