The Memory Partition Table - Tabor Electronics 5064 User Manual

Figure 4-8, the Memory Partition Table
The two main fields in the segment table are Segment number and
segment size. The Seg No (segment number) is an index field that
can has values only, from 1 to 2048. The Segment Size is always
associated with the segment number. You can program any
segment size from 16 to 2 M.
Use the Append key to add a segment at the end of the segment
list. If you highlighted a segment, the Append key turns
automatically to insert Use the Insert key to insert a segment at the
cursor location. The Delete key is used for deleting a segment at
the cursor position.
The Clear All key will remove all segments from the table and will
let you start designing your segment table from fresh.
Click on the Close to discard of the contents of the dialog box
without saving your last actions and to remove the Segment Table
from the screen.
The Save key saves the current session so you can start the
Memory Partition table from the same point after you close this
session. The Download key updates the 2074 with the present
segment table settings.
The Memory
waveforms. Use the memory partition table only if you
merged a few waveforms to one. The partition table then
divides the memory to the individual and original size of
each waveform. If you download waveforms using the
waveform studio, they already contain segment size and
there is no need for further use of the memory partition
table.
TIP
Partition table does
4
ArbConnection
The Control Panels
not download
4-15