Table of Contents
Advertisement
2074
User Manual
LAN Configuration
2-14
Figure 2-12, Model 2074 Configured for USB Operation
There are several parameters that you may have to set to establish
network communications using the LAN interface. Primarily you'll
need to establish an IP address. You may need to contact your
network administrator for help in establishing communications with
the LAN interface. To change LAN configuration, you need to
access the LAN 10/100 screen as shown in Figure 2-13. To access
this screen press the TOP menu button, then select the Utility soft
key and scroll down with the dial to the Remote Setup option and
press the Enter key. The LAN 10/100 soft key will update the
display with the LAN parameters.
Note there are some parameters that are shown on the display that
cannot be accessed or modified; These are: Physical Address and
Host Name. These parameters are set in the factory and are unique
for product. The only parameters that can be modified are the IP
Address, the Subnet mask and the Default gateway. Correct setting
of these parameters is essential for correct interfacing with the LAN
network. Description of the LAN settings and information how to
change them is given in the following.
Advertisement
Table of Contents
