Bit Waveform Data Point Representation - Tabor Electronics 5064 User Manual

is the low-byte and then high-byte.
D7 D6
Parameters
Name
<header>
<binary_block>
TRACe:DEFine<segment_number>,<length>
Description
Use this command to attach size to a specific memory segment. The final size of the arbitrary memory is
1M points (2M optional). The memory can be partitioned to smaller segments, up to 10k segments. This
function allows definition of segment size. Total length of memory segments cannot exceed the size of the
waveform memory.
The 2074 operates in interlaced mode where four memory cells generate one byte of
data. Therefore, segment size can be programmed in numbers evenly divisible by
four only. For example, 2096 bytes is an acceptable length for a binary block. 2002 is
not a multiple of 4, therefore the generator will generate an error message if this
segment length is used.
Parameters
Name Range
<segment_ 1 to 10k
number>
<length> 16 to
1(2)M
5-34
low-byte
D5 D4 D3 D2 D1
Figure ‎ 5 -3, 16-bit Waveform Data Point Representation
Type
Discrete
Binary
Type Default
Numeric 1
(integer only)
Numeric
(integer only)
high-byte
D0 D15 D14 D13 D12
Description
Contains information on the size of the binary block
that contains waveform coordinates.
Block of binary data that contains information on the
waveform coordinates.
NOTE
Description
Selects the segment number of which will be
programmed using this command
Programs the size of the selected segment. Minimum
segment length is 16 points, the maximum is limited
by the memory option that is installed in your
instrument either 1M or 2M
D11 D10 D9 D8