Zooming In On Waveform Segments - Tabor Electronics 5064 User Manual

4
ArbConnection
The Control Panels
The zoom in command operates between anchors. Anchors are
marked as left and right hand triangles. The default position of the
anchors is the start and the end of the waveform. To move an
anchor to a new location, click and hold on the triangle and drag the
anchor to left or right as required. If you move the left anchor to the
right and the right anchor to the left, the area between the anchors
will zoom in as you select this command.
Looking at the Waveform Map, as shown in Figure 4-32, you'll see
that the white portion is the zoomed area. Click and hold on the
white area and move your cursor around and the waveform screen
will be updated accordingly.
Figure 4-32, Zooming In on Waveform Segments
While zoomed in you can perform Autoline and sketch editing, or
zoom-in further by clicking and holding the mouse at one corner
and releasing the mouse button at the other corner.
Zoom Out
The zoom out restores the screen to display the complete
waveform.
Channel 1
The Channel 1 Waveform command updates the waveform screen
with the Channel 1 waveform. If you have not yet generated a
waveform for channel 1, the waveform screen will show a dc level
at vertical point 0.
4-41