Single Advance - Tabor Electronics 5064 User Manual

2074
User Manual
Test Results

Single Advance

Test Results
Test Results
6-18
Pass
Leave the same setup for the next test
Equipment: Oscilloscope, function generator
Preparation: (Same preparation as for previous step, except change
mode to single sequence advance)
1. Change Oscilloscope configuration to single
Test Procedure
1. Press the manual trigger button on the function generator and
observe that one cycle waveform advances through the
sequence table repeatedly with each external trigger signal.
Note that you need to press the Single mode on the
oscilloscope for each trigger advance
Pass
2. Remove the cable from 2074 channel 1
3. Repeat the test procedure as above for channel 2, 3 and 4
Pass
Fail
Note
Fail
Fail