Table of Contents
Advertisement
4
ArbConnection
Generating Waveforms Using the Equation Editor
Figure 4-43, the Pulse Composer Screen
File Commands
The File command has 4 command lines that control pulse
waveform files. Also use this command to print the active waveform,
or exit the pulse composer program. Description of the various
commands under File is given below.
New
The New (Ctrl+N) command will remove the waveform from the
screen. If you made changes to the waveform area and use the
New command, you should save your work before clearing the
screen. The New command is destructive to the displayed
waveform.
Open...
The Open... (Ctrl+O) command will let you browse through your
disk space for previously saved pulse waveform files and load them
to the pulse screen area. File extension that can be read to the
pulse composer is *.pls.
Save
The Save (Ctrl+S) command will store the active waveform in your
2074 directory with a *.pls extension. If this is the first time you save
4-57
Advertisement
Table of Contents
