Table of Contents
Advertisement
Figure 1 -8, ArbConnection Example - Typical Standard Waveforms Panel
Half Cycle
Waveforms
1-20
As a subset of the standard waveforms, the 2074 can generate
some of the waveforms, split into two half cycle. When generated
continuously, the second half cycle is delayed by a programmed
interval. In triggered mode, each trigger stimulates half cycle of the
selected function.
Three half cycle waveform shapes are available for generation:
Sine, triangle and square. Note when the half cycle function is
selected, both channels are placed in this mode automatically.
The repetition rate of the half cycle waveforms is given in units of
Hz. Both channels share the same clock source and therefore,
when a standard function shape is selected for re-play, the
frequency of the half cycle waveforms is the same at the output
connectors of both channels. Also, when half cycle waveforms are
selected, both channels share the same run mode, as well as
delayed trigger and re-trigger settings.
Figure 1-7 shows typical front panel for the standard waveform
display and Figure 1-8 shows typical standard waveform panel as
displayed when ArbConnection is used for remote programming.
Figure 1-9 shows typical front panel for the half cycle waveforms
display.
Advertisement
Table of Contents
