Table of Contents
Advertisement
The System Panels
7. ArbConnection can communicate with one instrument at a time
and therefore, highlight the master IP address and then click on
Communicate. Regardless, each of the assigned addresses will
be tested for LAN accessibility and made available in the Link
field for future programming.
Figure 4-25, Assigning Master and Slave Addresses
8. The last step is to activate the synchronization. This is done
from the X-Instruments Synchronization dialog box, as shown
in Figure 4-23. Click on Activate to start the synchronization,
click on the same button to toggle synchronization off.
9. Adjust the parameters and the functions on the master and
slave units however, bear in mind that some functions are
shared by all modules and therefore can only be modified on
the master instrument. Chapter 3 describes the synchronization
aspects
and
specifications and limitations.
The System tab provides access to a group of panels that control
some general system parameters and provides access to the
calibration. There are two panels in this group: General/System,
which provides access to some system commands, utilities and
filters; and Calibration, which provides access to the calibration
remote calibration utility. Note however, that access to the
calibration panel is permitted to qualified service persons and
requires special user name and password. Information how to
access the calibration panel is given in Chapter 7.
The System set of panels are shown in Figure 4-26. Each of the
panels is described below.
Appendix
A
lists
4
ArbConnection
The Control Panels
the
multi-instruments
4-33
Advertisement
Table of Contents
