Front Panel Auxiliary Menus - Tabor Electronics 5064 User Manual

Soft TOP Auxiliary
Key Menu Function
↓D Auxiliary
A Pulse Generator
B
C
D
↓D
↓D
↓D
↓D
↓D
↓D
↓D
↓D
A Counter/Timer
B
C
D
↓D
↓D
A Half Cycle
B
C
D
↓D
↓D
↓D
A X-Inst Sync,
B
C
(*) ↓D denotes you have to scroll down to access the menu. Scroll using the arrows up or down or the dial.
Table -5, Front Panel Auxiliary Menus
nd
2 Level
Menu
Apply Changes
Period
Delay
Rise Time
High Time
Fall Time
High Level
Low Level
Polarity
Double State
Channel State
Sync Position
Counter Function
Display Time
Gate Time
Trigger Level
Trigger Slope
Reset/Arm
Half Cycle Shape
Delay
Frequency
Amplitude
Offset
Phase
Couple State
Properties
Slaves IP Address
Using the Instrument
2074 Front Panel Menus
Notes
Provides access to the following auxiliary
functions: Digital Pulse Generator,
Counter/Timer, Half Cycle waveforms, Multi-
instrument synchronization and Digital Patterns.
Press this button to accept modifications of
pulse parameters.
Programs the period of the pulse
Programs the delay from the start of the pulse
Programs the pulse rise time parameter
Programs the pulse high time parameter
Programs the pulse fall time parameter
Programs the pulse high level parameter
Programs the pulse low level parameter
Programs the pulse polarity parameter
Toggles double pulse state on and off
Programs the channel programmability state
Programs the sync pulse position parameter
Selects the counter/timer measurement function
Selects between continuous and single
measurement cycles
Programs the counter gate time
Programs the trigger level for the counter input
Programs the trigger slope for the counter input
Resets the counter display and arms the counter
for the next measurement cycle
Selects the half cycle waveform shape. Select
between sine, triangle or square waveforms
Programs the delay between the half cycles
Programs the delay from the start of the pulse
Programs the half cycle Amplitude
Programs the half cycle amplitude offset
Programs the start phase of the sine and
triangular waveforms
Programs the half cycle start phase angle
Toggles master/slave mode on and off
Provide access to selection of the master and
delay between adjacent instruments
Allows addition of slave units. Every added IP
address is automatically added as slave
3
3-11