Table of Contents
Advertisement
Configuring your LAN setting does not automatically
select the LAN as your active remote interface. Setting a
remote interface is done from the Select interface menu.
Information how to select and Interface is given
herinbefore.
Figure 2-13, LAN Configuration Screen
There are three LAN parameters in this screen that can be modified
and adjusted specifically to match your network setting; These are
described below. Consult your network administrator for the setting
that will best suit your application.
•
IP address - The unique, computer-readable address of a
device on your network. An IP address typically is represented
as four decimal numbers separated by periods (for example,
192.160.0.233). Refer to the next section - Choosing a Static IP
Address.
•
Subnet mask - A code that helps the network device determine
whether another device is on the same network or a different
network.
•
Gateway IP - The IP address of a device that acts as a
gateway, which is a connection between two networks. If your
network does not have a gateway, set this parameter to 0.0.0.0.
Choosing a Static IP Address
For a Network Administered by a Network Administrator
Configuring the Instrument
Selecting a Remote interface
Note
2
2-15
Advertisement
Table of Contents
