Changing The Sample Clock Frequency - Tabor Electronics 5064 User Manual

Changing the
Sample Clock
Frequency
1
3. Press M, k, x1 or m to terminate the modification process
Alternately, you can modify the frequency value with the dial and
arrow keys but then the termination of the process is by pressing
Enter only.
If you use the dial or arrow keys to modify the frequency
parameter, the output is updated immediately as soon as
you modify the parameter. The final value will be locked
in as soon as you press Enter. If you choose to leave the
old value, press Cancel to terminate the process and to
discard of any change made to this parameter
The frequency of the sample clock will affect the output waveform
only if arbitrary or sequenced waveforms are generated. First select
an arbitrary waveform as described earlier and then proceed with
sample clock frequency modification.
Observe Figure 3-6 and modify the sample clock using the following
procedure. The index numbers in Figure 3-6 correspond to the
procedure steps in the following description.
Figure 3-6, Modifying Sample Clock Frequency
1. Press the Sample Clock soft key to select the sample clock
parameter
2. Use the numeric keypad to dial the new sample clock frequency
value
3. Press "M" for MS/s, "k" for kS/s, "x1" for S/s, or "m" for mS/s to
Using the Instrument

Changing the Sample Clock Frequency

Note
2
3
3
3-15