Table of Contents
Advertisement
2074
User Manual
USB Configuration
2-8
option and press the Enter key. The GPIB soft key will update the
display with the GPIB address parameter. The default address is 4.
To modify the address, press the Enter key and use the dial or
keypad to select the new address. Press Enter for the 2074 to
accept the new address setting.
Configuring your GPIB address setting does not
automatically select the GPIB as your active remote
interface. Setting a remote interface is done from the
Select interface menu. Information how to select and
Interface is given hereinbefore.
Figure 2-2, GPIB Configuration Screen
The USB requires no front panel configuration parameters.
Following simple installation steps as shown later, just connect your
Tabor 2074 to your PC using a standard USB cable and the
interface will self configure.
generator to your PC, the new hardware will be detected and the
message as shown in Figure 2-3 will appear:
Note
The first time you connect the
Advertisement
Table of Contents
