Burst; Gated; 1 -1, Run Modes And Trigger Source Options Summary; Delayed Trigger - Tabor Electronics 5064 User Manual

Burst

Gated

1-16
The burst mode is an extension of the triggered mode where the
Model 2074 can be programmed to output a pre-determined
number of waveforms. Note that the burst run mode cannot be
applied to sequenced waveform because the two functions share
the same circuit and therefore, whenever counted burst is selected
for sequenced waveforms, the generator will issue a setting conflict
error.
‎
Table

1 -1, Run Modes and Trigger Source Options Summary

Run Mode Trigger Option
Continuous External
Bus
Mixed

Delayed Trigger

Re-Trigger
(*) Output signal is toggled on and off
using interface triggers
Triggered External
Bus
Mixed
Delayed Trigger
Re-Trigger
Counted Burst External
Bus
Mixed
Delayed Trigger
Re-Trigger
(*) Not in conjunction with Re-Trigger
(**) Not in conjunction with Mixed

Gated

External
Bus
Mixed
Delayed Trigger
Re-Trigger
In gated mode, the 2074 generates output waveforms between two
gating signal. Only hardware triggers can be used to open and
close the gate. The gate opens on the first trigger transition and
closes on the second transition. Trigger level and trigger slope are
programmable. Trigger delay and re-trigger do not apply to the
gated run mode.
Status
Disabled
Active(*)
Disabled
Active
Disabled
Active
Active
Active
Active
Active
Active
Active
Active(*)
Active
Active(**)
Active
Active
Disabled
Active
Disabled