Table of Contents
Advertisement
Instrument
Control
Commands
Keyword
:INSTrument
[:SELect]
:COUPle
:MODE
:DELay
:SLAVe
:DELete
:INSert
:STATe
:OUTPut
:LOAD
[:STATe]
:FILTer
[:LPASs]
:SYNC
:POSition
[:SOURce]
:ROSCillator
:SOURce
:FREQuency
[:CW]
:RASTer
:SOURce
:VOLTage
[:LEVel]
[:AMPLitude]
:OFFSet
:PHASe
[:OFFSet]
:FUNCtion
:MODE
5-14
This group is used to control output channels and their respective
state, amplitude and offset settings, as well as the waveform mode.
You can also set the phase offset between channels and select
filters to re-structure the shape of your waveform. Multiple
instruments can be synchronized with these commands, as well.
The output frequency and the reference source are also selected
using commands from this group. Factory defaults after *RST are
shown in the Default column. Parameter range and low and high
limits are listed, where applicable.
Table
5 -2, Instrument Control Commands Summary
Parameter Range
1 | 2 | 3 | 4 |...n
MASTer | SLAVe
0 to 20
<LAN_IP_address>
<LAN_IP_address>
OFF | ON | 0 | 1
50 to 1e6
OFF | ON | 0 | 1
NONE | 25M | 50M | 60M | 120M
0 to 1e6-1 (0 to 2e6-1 with option 2M)
INTernal | EXTernal
10e-3 to 100e6 | MINimum | MAXimum
1.5 to 250e6 | MINimum | MAXimum
INTernal | EXTernal
10e-3 to 10 | MINimum | MAXimum
-4.995 to 4.995
0 to 1e6-1 (0 to
2e6-1 with option 2)
FIXed | USER | SEQuence | MODulation | COUNter | PULSe |
HALFcycle
Default
1
MAST
0
0
50
0
NONE
0
INT
1e6
1e7
INT
5
0
0
FIX
Advertisement
Table of Contents
