Programming Amplitude And Offset - Tabor Electronics 5064 User Manual

1
4. Press "m" for mV, or "x1" for volts to select the suffix letter.
5. Press Enter to lock in the value
Alternately, you can modify the amplitude value with the dial and
arrow keys but then the termination of the process is by pressing
Enter.
Offset is programmed the same way as amplitude except select
Offset from the soft key menus to access the offset parameter.
If you use the dial or arrow keys to modify the amplitude
or offset parameters, the output is updated immediately
as soon as you modify the parameter. The final value will
be locked in as soon as you press Enter. If you choose
to leave the old value, press Cancel to terminate the
process and to discard of any change made to this
parameter
Figure 3-7, Programming Amplitude and Offset
Using the Instrument
Programming the Amplitude and Offset
Note
4
3
5
3, 6
3-17