Psk Modulation Programming - Tabor Electronics 5064 User Manual

50 / 100 / 200 ms/s four channel arbitrary waveform generator
Table of Contents

Advertisement

PSK Modulation
Programming
PSK:TYPE{BPSK|QPSK|OQPSK|8PSK|16PSK|USER}(?)
Description
This selects between the various (n)PSK modulation schemes.
Parameters
Name
BPSK
QPSK
OQPSK
DQPSK
5-46
Use the following command for programming the PSK parameters.
The PSK functions use pre-defined table settings. In case the
standard table do not suit the application you can design your own
(n)PSK data using the User PSK data table entry option. Note that
the carrier waveform frequency (CW) setting is common to all
modulation schemes.
Type
Default
Discrete
BPSK
Discrete
Discrete
Discrete
Description
Selects the Binary Phase Shift Keying (BPSK)
modulation type. In this mode, the instrument shifts
from 0 to 180 at a rate determined by the
PSK:BAUD command and in a sequence as
programmed by the PSK:DATA table.
Selects the Quadrature Phase Shift Keying (QPSK)
modulation type. In this mode, the instrument
responds to 2 input bits that correspond to four
phases of the carrier wave. The symbols are shifts at
a rate determined by the PSK:BAUD command and
in a sequence as programmed by the PSK:DATA
table.
Selects the Offset Phase Shift Keying (OPSK)
modulation type. The mapping is the same as for the
QPSK except the element of I is moved first and then
the element of Q is moved if the status changes from
one to another. These two steps are carried out
within the time of one step of QPSK. By shifting the
movement of the Q element, the status can be
changed without going through the origin even if a
change of 180 occurs. Because one symbol period
is calculated in two steps, an even value must be
used for oversampling. The symbols are shifts at a
rate determined by the PSK:BAUD command and in
a sequence as programmed by the PSK:DATA table.
Selects the /4-shifted Differentially encoded QPSK
modulation type. In this mode, the symbol is located
at the position where the phase is shifted from the
current symbol position by 45 from the value of the
next data symbol. The first symbol position is defined
by QPSK. pre-defined values. /4DQPSK uses both
the QPSK and another four-point table rotated by

Advertisement

Table of Contents
loading

Related Products for Tabor Electronics 5064

This manual is also suitable for:

10742074

Table of Contents