New Hardware Found And Software Installed - Tabor Electronics 5064 User Manual

Figure 2-11, New Hardware Found and Software installed
The process above detected a USB device and installed the
software for it, then it has assigned a Serial Port address to the
USB post. In fact, this ends the process unless you want to verify
that the drivers and the port are correctly assigned on your PC.
To make sure your USB port and the Tabor 2074 configured
correctly, compare your Device Manager to the example in Figure
2-12.
Configuring your USB setting does not automatically
select the USB as your active remote interface. Setting a
remote interface is done from the Select interface menu.
Information how to select and Interface is given
hereinbefore.
Configuring the Instrument
Selecting a Remote interface
Note
2
2-13