Table of Contents
Advertisement
4
ArbConnection
The Control Panels
printer setup, or print the waveform page.
Figure 4-31, the Open Waveform Dialog Box
Exit
The Exit command ends the current Wave Composer session and
takes you back to the Panels screen. If you made changes to your
waveform since it was last saved, the Wave Composer will prompt
you to Save or Abandon changes these changes.
Edit Commands
The Edit commands are used for manipulating the waveform that is
drawn on the screen. The editing commands are explained in the
following paragraphs.
Autoline
The Autoline command lets you draw straight-line segments. To
draw a line the left mouse button at the start point. Click again at
the next point and then click on the right mouse button to terminate
this operation.
Sketch
The Sketch command lets you draw free-hand segments. To draw a
line using this command click and hold the left mouse button at the
start point. Release the mouse button when you want to stop and
then click on the right mouse button to terminate this operation.
Smooth
The Smooth command lets you smooth out rough transitions on
your waveform. This is done mathematically by multiplying
waveform coordinates by the non-linear portion of a cubic parabola.
The Smooth operation is done on segments of the waveform that
4-39
Advertisement
Table of Contents
