Programming Parameters; Back-Up And Copying Parameter Settings - Danfoss VLT DriveMotor FCP 106 Programming Manual

Programming

2.4 Programming Parameters

Procedure:
2 2
1. Press [Menu] until the arrow in the display
indicates the desired menu: "Quick Menu" or
"Main Menu".
2.
Press [
groups.
3. Press [OK] to select a parameter group.
4.
Press [
in the specific group.
5. Press [OK] to select the parameter.
6.
Press [
7. Press [OK] to save the new setting. Press [Back] to
abort
8. Press [Back] to return to the previous menu.
14
VLT
▲ ▼
] [ ] to browse through the parameter
▲ ▼
] [ ] to browse through the parameters
▲ ▼ ▶
] [ ] [ ] to change the parameter value.
®
DriveMotor FCP 106 and FCM 106 Programming Guide
2.5 Back-up and Copying Parameter
Settings
NOTICE
Stop the motor before backing-up or copying parameter
settings.
Data storage in LCP
Once the set-up of a frequency converter is complete,
store the data in the LCP. Alternatively, use a PC with MCT
10 Setup Software tool to perform the same back-up.
1. Go to parameter 0-50 LCP Copy
2. Press [OK]
3. Select [1] All to LCP
4. Press [OK]
Data transfer from LCP to frequency converter
Connect the LCP to another frequency converter and copy
the parameter settings to this frequency converter as well.
1. Go to parameter 0-50 LCP Copy
2. Press [OK]
3. Select [2] All from LCP
4. Press [OK]
MG03N102 - Rev. 2013-12-02