ABB IRB 4600 Foundry Prime Product Manual page 303

Refitting the stop pin, axis 1
Use this procedure to refit the stop pin axis 1.
1
2
3
4
5
6
Product manual - IRB 4600 Foundry Prime
3HAC040585-001 Revision: M
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
to the robot, before entering the robot
working area.
Clean the joints that have been opened. See
Cut the paint or surface on the robot before
replacing parts on page 201
Fit the two o-rings on the stop pin.
Note
The o-rings are not used when bracket (D)
is installed.
Fit the stop pin on the bracket.
Note
The small spike on the bracket shall be
pointing downwards for correct fitting of the
stop pin.
Secure the stop pin together with bracket
(D) on the frame with its attachment screws.
Use Locking liquid
Seal and paint the joints that have been
opened. Also repair possible damages of
the special Foundry Prime paint coat of the
robot. See Cut the paint or surface on the
robot before replacing parts on page
© Copyright 2013-2018 ABB. All rights reserved.
4.6.1 Replacing stop pin axis 1
Note
See the figure in
• Location of stop pin axis 1 on
page 301
C
B
xx0800000453
Parts:
• A: Bracket
• B: Stop pin
• C: Small spike
3HAB7116-1 (Loctite 243).
Tightening torque: 10 Nm
See the figure in
• Location of stop pin axis 1 on
page 301
201.
Continues on next page
4 Repair
Continued
A
303