Changing The Oil, Axis-4 Gearbox - ABB IRB 4600 Foundry Prime Product Manual

3.5.6 Changing the oil, axis-4 gearbox

Location of oil plugs
The axis-4 gearbox is located in the front of the upper armhouse.
The oil plug is shown in the figure.
xx0800000307
A
Required equipment
Equipment
Lubricating oil
Oil collecting vessel
Plastic hose
Funnel
Product manual - IRB 4600 Foundry Prime
3HAC040585-001 Revision: M
Oil plug, for filling and draining
© Copyright 2013-2018 ABB. All rights reserved.
3 Maintenance
3.5.6 Changing the oil, axis-4 gearbox
Note
Where to find information of the type of oil,
article number and the amount in the gear-
box, see section Type of lubrication in gear-
boxes on page 151
The capacity of the vessel must be sufficient
to take the complete amount of oil.
Used for venting the gearbox during draining.
A suitable hose would be a hose normally
used for compressed air.
Length: minimum 300 mm. Diameter: 5 mm.
xx1200000862
Continues on next page
177