Jtag Flash Programming Interface - Philips LPC214 Series User Manual

Philips Semiconductors
Volume 1
Table 314: IAP Status codes Summary
Status
Code
4
5
6
7
8
9
10
11

21.10 JTAG Flash programming interface

Debug tools can write parts of the flash image to the RAM and then execute the IAP call
"Copy RAM to Flash" repeatedly with proper offset.
User manual
Mnemonic
SRC_ADDR_NOT_MAPPED
DST_ADDR_NOT_MAPPED
COUNT_ERROR
INVALID_SECTOR
SECTOR_NOT_BLANK
SECTOR_NOT_PREPARED_
FOR_WRITE_OPERATION
COMPARE_ERROR
BUSY
Rev. 01 — 15 August 2005
Chapter 21: Flash Memory
Description
Source address is not mapped in the memory map.
Count value is taken in to consideration where
applicable.
Destination address is not mapped in the memory
map. Count value is taken in to consideration where
applicable.
Byte count is not multiple of 4 or is not a permitted
value.
Sector number is invalid.
Sector is not blank.
Command to prepare sector for write operation was
not executed.
Source and destination data is not same.
Flash programming hardware interface is busy.
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
UM10139
311