Table of Contents
Advertisement
Philips Semiconductors
Volume 1
24.4.5 Prefetch Abort mode
RealMonitor uses four words on entry to its Prefetch abort interrupt handler.
24.4.6 Data Abort mode
RealMonitor uses four words on entry to its data abort interrupt handler.
24.4.7 User/System mode
RealMonitor makes no use of this stack.
24.4.8 FIQ mode
RealMonitor makes no use of this stack.
24.4.9 Handling exceptions
This section describes the importance of sharing exception handlers between
RealMonitor and user application.
24.4.10 RealMonitor exception handling
To function properly, RealMonitor must be able to intercept certain interrupts and
exceptions.
shared between RealMonitor and application. If user application requires the exception
sharing, they must provide function (such as app_IRQDispatch ()). Depending on the
nature of the exception, this handler can either:
In a simple case where an application has no exception handlers of its own, the
application can install the RealMonitor low-level exception handlers directly into the vector
table of the processor. Although the IRQ handler must get the address of the Vectored
Interrupt Controller. The easiest way to do this is to write a branch instruction (<address>)
into the vector table, where the target of the branch is the start address of the relevant
RealMonitor exception handler.
User manual
Figure 72
illustrates how exceptions can be claimed by RealMonitor itself, or
•
Pass control to the RealMonitor processing routine, such as rm_irqhandler2().
•
Claim the exception for the application itself, such as app_IRQHandler ().
Rev. 01 — 15 August 2005
UM10139
Chapter 24: RealMonitor
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
323
Advertisement
Table of Contents
